The function of the snow stopper is to limit the snow and ice from sliding on sloping roof surfaces and it is a good supplement to the regular snow fence. They distribute the snow load over the entire roof and keep the snow in place until it melts or the roof can be shovelled.
Upon the installation of a snow stopper and/or snow fence, it is of the utmost importance to adapt the amount to the actual geographic location, amount of precipitation and the design of the roof. Remember that so-called snow pockets can form. This is where more snow ends up and then an extra snow fence or snow stopper is needed to keep the snow in place.
When there is a risk of overloading the snow fence and the roof, the roof must be shovelled in order to prevent damages to the roof, as well as accidents.
As opposed to the snow fence, the snow stopper is not approved for anchoring personal fall protection.
Tubes are extended simply with self-tapping stainless steel screws. In order to facilitate the extension, they are pre-drilled at one end and crimped at the other.
The bracket is used on waterproof membrane roofs and profiled sheet metal roofs. Installs easily with EPDM seals and the associated screw kit.
The mounting plate is used for the attachment to the sealing surface on asphalt and artificial material-based waterproofing membranes with roof underlays of tongue-in-groove board, min 17 mm. No damage is done to the waterproofing membrane.
The mounting plate is specially developed for shingle roofs and is combined with brackets for smooth roofs. Installed under the waterproofing membrane. It may be a good idea to plan the roof safety measures before applying the sealing surface.